Dein Warenkorb ist leer

Wayne Rich 3.4" side bite pair in solid fiberglass, Futures-compatible — the small outside fins that turn a single-fin board into a 2+1.
Wayne Rich 3.4"-Side-Bite-Paar in Solid Fiberglass, Futures-kompatibel – die kleinen äußeren Finnen, die aus einem Singlefin-Board ein 2+1 machen.
Side Bites machen aus einem Singlefin-Board ein 2+1: Die Mittelfinne lenkt weiterhin, die beiden kleinen Finnen geben Halt durch den Turn und Drive aus dem Bottom Turn. Der Preis ist ein Teil des losen, pivotfreudigen Gefühls, das eine Singlefinne für sich allein hat – deshalb ist die Größe die eigentliche Entscheidung.
Diese Größe
Mit 3.4" sind das kleine Side Bites – genug, um das Tail zu beruhigen, ohne das Board auf ein Thruster-Gefühl festzulegen.
Konstruktion
Solid Fiberglass ist die steifere, schwerere der beiden Konstruktionen – weniger Flex, direkterer Drive.
Das Template
Rich zeichnet ein Side Bite mit mehr Rake als das Haus-Template, was etwas vom sofortigen Biss gegen einen längeren, weicheren Bogen eintauscht.
Spezifikationen
Konfiguration
Side Bites – Paar
Finnensystem
Futures-kompatibel
Konstruktion
Massives Fiberglas
Basis
3.54"
Tiefe
3.44"
Farben
Smoke, Red
Designer
Wayne Rich
Hergestellt von
True Ames, Santa Barbara CA
These run slightly more upright than a standard side bite, with a thinner tip and relief through the trailing edge, which Wayne Rich built for precise turns rather than just hold — adding them to a center fin gives you increased stability plus lift and projection.
Run these on a mid-length or smaller longboard 2+1 where you want a little more bite but a still-loose feel — they grip on edge without clamping the tail down the way a 4.0 inch would, and they keep the single-fin glide alive on steeper drops. Pair them with the Power Tilt for the intended setup, drop your center fin size when you add them, and size up to the 4.0 for bigger boards, riders, or waves.
The Wayne Rich Side Bites are a two-fin set designed by Wayne Rich and foiled by True Ames; this is the 3.4" Futures version in solid fiberglass, the smaller of two sizes alongside the 4.0". The template runs slightly more upright than a standard side bite, with a thinner tip and relief through the trailing edge. Rich designed them to complement his Power Tilt center fin in 2+1 setups on mid-lengths and smaller longboards, though they pair with most center fins.
